ConveyLinx Ai3 RC/FC

The power supply is a major factor in the design, installation and cost of a motor roller system. Whilst the range of the cabling is important, cable connections need to be quick and easy to install whilst maintaining the highest possible level of safety.

ConveyLinx-Ai3 is a solution that significantly simplifies and speeds up both the installation of the control unit and its replacement. The key to this is its cable piercing technology, whereby needles penetrate the insulation of the cable and make secure contact with the current conducting wires. No need for wire stripping or time-consuming press, screw, or soldering fixtures.
ConveyLinx-Ai3 is available in two variants – RC and FC.
The RC variant (Round Cable) enables the use of 6mm² round cables for the motor voltage supply and 2.5mm² cables for the logic voltage supply. The 6mm² cable, offers an extensive cable length range.
The FC variant (Flat Cable) uses an ASI standard ribbon cable and is suitable for carrying the motor voltage supply and separate logic voltage supply. By using a 2.5mm² ASI cable a high degree of standardization in the wiring is possible while at the same time simplifying the overall construction. With ConveyLinx-Ai3 a much easier and quicker method of cabling and connection is assured.